BUILDING INSTRUCTIONS

STEP 0: OUR RECOMMENDATIONS

We recommend building a four-wheeled vehicle and driving the two rear wheels. We also recommend using M16 axles to increase stability (if you want to use M8 axles, consider using the corresponding translators).

Every project and structure is different, therefore we can unfortunately only provide general information here. If you should need help, don't hesitate to CONTACT US : )

STEP 1: PREPARATIONS AND SOURCING

Make sure, that you have a 3D-printer (if you shouldn't have one, maybe ask a friend (if you shouldn't have one, maybe try to make some friends) or visit our TRAMANN SHOP).

If you haven't already, please take a look at the requiered PARTS, scroll down to ADDITIONAL PARTS and buy them. If you shouldn't be able to get something from that list, again try friends or visit our TRAMANN SHOP.

STEP 2: PRINTING PARTS

Please print the following PARTS.

STEP 3: ASSEMBLING

Please assemble the printed parts by attaching two wheel halves with M8 screws, clamping the rubber between them und repeat this step four times for your four wheels. Connect two of the wheels to the steering of the front axle of your vehicle through the bearings. The other two wheels are also attached with bearrings, but this time to the rear axle that passes through the powertrain main holders which then are connected with your structure. Also connect the motors, the drive gears, the brakes and the brake disks.

STEP 4: FINISHING

Congratulations! You made it, your TMS should now be moving your vehicle! We are very proud of your accomplishment!


If you are having questions, feedback, ideas, need for support, suggestions, something else?
Always feel free to CONTACT US : )