BUILDING INSTRUCTIONS

STEP 0: OUR RECOMMENDATIONS

We recommend carving the parts out of wood using a CNC milling machine (but of course you can also use your 3D printer and print).

If you should need help, don't hesitate to CONTACT US : )

STEP 1: PREPARATIONS AND SOURCING

Make sure, that you have a CNC milling machine (or a 3D printer) (if you shouldn't have one, maybe ask a friend (if you shouldn't have one, maybe try to make some friends) or visit our TRAMANN SHOP).

If you haven't already, please take a look at the requiered PARTS, scroll down to ADDITIONAL PARTS and buy them. If you shouldn't be able to get something from that list, again try friends or visit our TRAMANN SHOP.

STEP 2: CARVING PARTS

Please carve the following PARTS.

STEP 3: ASSEMBLING

Glue the magnets into the four outer holes of the shell bottom, insert the batteries the right way round into the recesses provided, push the iron plates onto the ends as contacts and bend them slightly outwards. Place the large cloth and the pens in the box.

Now glue the four remaining magnets into the outer holes of the shell top, solder the LEDs to the resistor in series and connect them on the outside with iron plates that will later be pressed onto the iron plates of the shell bottom. Then wrap the inside cover plate with the small cloth once and screw it to the shell top to conceal the electronics.

STEP 4: FINISHING

Congratulations! You made it, your TPB should now be finished! We are very proud of your accomplishment!

A little tip to help the environment: please note that you can replace the cartridges in ballpoint pens. You don't have to throw away the whole pen, just as you don't throw away your flashlight or your mobile phone because the battery has run out either.


If you are having questions, feedback, ideas, need for support, suggestions, something else?
Always feel free to CONTACT US : )